AICO EI3014 Heat Alarm

The 3000 series by AICO is their market leading product and is also advertised on national television across the United Kingdom. 

Specifically, the Ei3014 is houses a single sensor that uses a thermistor (heat sensor) which fast detects changes in temperature and triggers the alarm at 58DegC  

The 3000 range is also specified by social landlords and dependant on the layout of the dwelling, could also be used in HMO's. Critically, if you are planning to install the 3000 range in a House of Multi Occupancy, ensure you check local fire regualtions.

An EI3000MRF SmartLINK module can be added for wireless interconnection and data extraction but allow us to explain what wireless interconnection means below. 

Also note that by using the Ei3000MRF's method of linking your alarms, you can only interconnect up to 12 alarms/units which of course, could include Ei3014's, Ei3016's, Ei3018's, Ei3024's and Ei3028's. By using what your electrician would term as hardwiring however, you can include up to 20 alarms/units on the same circuit - provided you use a maximum of 250metres of interconnecting cable. 

For optimum safety as well as in keeping with local fire safety standards for your area, you could be installing more than one alarm/unit from the range. It is not always practical however or indeed possible, for a suitably qualified person to interlink each alarm from within the 3000 range, with electrical cable. 

Within this 3000 range, you can therefore purchase Ei3000MRF's (x1 link module 'Ei3000MRF' would be required for each unit) which will then only require you to supply electrical power to each unit seperately/directly, as opposed to interlinking electrical cables all around your property by pulling up floorboards etc. Once each unit is then recieving its very own direct electrical cable feed, the Ei3000MRF's are then correctly installed to each unit and they then create the desired 'linkable system' that in the event of an activation, each unit then sounds it's 85dB(A) alarm simultaneously. 

Put another way, if your suitably qualified electrician can access floorboards easily enough above the room where this alarm is to be fitted, they may opt not to use the Ei3000MRF's because the electrical cables could therefore all be interlinked, thus still allowing the desired simultaneous alarm across all units in the the event of an activation.       

Mains powered but with a 10 year rechargeable lithium cell back-up

An EI3000MRF SmartLINK module can be added for wireless interconnection and data extraction, as described above.

Compatible with EI3016, EI3018, EI3024 & EI3028, as well as linkable to the EI3000MRF Smartlink

AudioLINK data extraction technology

Easi-fit base &10 year life.

This unit should only be fitted by a qualified proffesional.